Nuvoton Technology Corporation

Alain Bismuth

Ziv Hershman

Ilan Margalit

Dana Agur

Josef Nevo

A method includes providing one or more signals to an electronic device for performing a test procedure that involves programming a One-Time Programmable (OTP) memory in the electronic device. A verification is made as to whether connection of the one or more signals to the electronic device is stable, by performing a sequence of one or more iterations, each iteration including (i) determining, from among a set of scratchpad addresses in the OTP memory, an address that is available for programming, (ii) writing a test value to the address, and then (iii) reading the test value from the address. If the read test value differs from the written test value, re-tuning of the connection of the one or more signals is initiated. Only when the connection is verified as stable by the sequence of iterations, the OTP memory is programmed in accordance with the test procedure.

Reliable programming of one-time programmable (OTP) memory during device testing

A method for measuring an input capacitance of a pin of an electronic device includes, using a tester including Pin Electronics (PE), obtaining a first capacitance measurement while the pin is disconnected from the PE, and a second capacitance measurement while the pin is connected to the PE. The input capacitance of the pin is calculated from the first and second capacitance measurements.

Measuring input capacitance with automatic test equipment (ATE)

An apparatus for automatic testing of an electronic device includes a pad interface unit and measurement circuitry. The pad interface unit is configured to connect to pads of the electronic device. The measurement circuitry is configured to select a circuit path in the electronic device that passes via a digital signal pad from among the pads, which is configured to carry a digital signal, to estimate a non-binary measure indicative of an electrical resistance of the circuit path, by performing current-voltage measurements using the pad interface unit, and to determine, based on the non-binary measure, whether the digital signal pad passes or fails a test.

Contact quality testing

A method of testing an integrated circuit device, which involves receiving, by a processor, a test definition indicating a sequence of acts to be performed by an automated test equipment in testing an integrated circuit device. The test definition includes indications of test cycles and timings of events in the cycles. The method includes scanning the received test definition, by the processor, for switch time points for which a timing of events in a first cycle immediately preceding the switch time point is different from a timing of events in a second cycle immediately following the switch time point, determining problematic switch time points for which the combined rest duration from a specific event in the first cycle to a corresponding specific event in the second cycle is shorter than a minimal switch period of the automated test equipment, changing the received test definition by extending a length of the cycles immediately preceding the determined problematic switch time points and providing the changed test definition for testing the integrated circuit device by the automated test equipment.

Growing community of inventors

Kibbutz Beth Rimon, Israel

Alain Bismuth