Kollmorgen Technologies Corporation

Aengus Murray

Francis McMullin

John V Byrne

Arthur Stone

Maurice Buckley

A direct current brushless electric motor has a rotor, and a stator with inwardly extending teeth, between each pair of which a winding slot is defined. The radially inward face of each tooth has a dummy slot shaped so the reluctance forces between rotor and stator due to the presence of the dummy slots are the same as those due to the winding slots. Motor control arrangement incorporates a current feedback loop based on the incoming phase of each phase combination in the phase energization sequence in a driving mode and phase changeover may be initiated by Hall devices, two for each transition point, underlying the axial ends of the rotor magnets. The control arrangement may incorporate a pulse width modulation power supply permitting the establishment of bias currents under motor standstill conditions.

Electrical drive systems

In a sensor having a drive winding for establishing a forward field, an electrically conductive screen is displaceable relative to a sense winding. In the presence of the drive field, eddy currents are generated in the screen to establish a counter-field opposing the forward field, so that the sense winding is shaded by the screen to a varying extent during relative displacement of screen and sense winding and the voltage induced in the sense winding is accordingly correspondingly varied. Application of a high frequency input to the drive winding results in a modulated output from the sense winding which may be demodulated to provide a signal indicative of screen position relative to sense winding. The position signal may be further processed to provide a speed signal. The sensor may assume a multiplicity of linear or planar, rotational and axial or solenoidal configurations.

Position and speed sensors

A direct current brushless electric motor has a rotor, and a stator with inwardly extending teeth, between each pair of which a winding slot is defined. The radially inward face of each tooth has a dummy slot shaped so the reluctance forces between rotor and stator due to the presence of the dummy slots are the same as those due to the winding slots. Motor control means incorporate a current feedback loop based on the incoming phase of each phase combination in the phase energization sequence in a driving mode and phase changeover may be initiated by Hall devices, two for each transition point, underlying the axial ends of the rotor magnets. The control means may incorporate a pulse width modulation power supply permitting the establishment of bias currents under motor standstill conditions.

Growing community of inventors

Dublin, Ireland

Aengus Murray