Uvic Industry Partnerships Inc.

Adrian Engel

Subhasis Nandi

Boost-type switch-mode rectifiers (SMR) commonly use a resistor or a magnetic current sensor to measure the instantaneous input or inductor current that is used as the feedback to the current controller. A novel current sensorless scheme is described that computes the inductor current from the measured inductor voltage in a single-phase boost-type SMR using an adaptive low pass filter. This calculation requires an estimate of the inductance and the equivalent series resistance of the inductor coil. Both these parameters are dependent on operating conditions and are updated continuously. This is done using an adaptive model of the inductor that computes these parameters of the inductor once in every half cycle of the input current. The adaptation scheme is robust against parameter variations. Simulation and experimental results confirm the effectiveness of the proposed technique which provides comparable performance to standard measured feedback current scheme both under steady-state and transient conditions.

Growing community of inventors

Remscheid, Germany

Adrian Engel